Designing a cleanroom for assembly work of Hanza Toolfac Oy
Basnet, Basu (2022)
Basnet, Basu
2022
All rights reserved. This publication is copyrighted. You may download, display and print it for Your own personal use. Commercial use is prohibited.
Julkaisun pysyvä osoite on
https://urn.fi/URN:NBN:fi:amk-2022052311299
https://urn.fi/URN:NBN:fi:amk-2022052311299
Tiivistelmä
The objective of the bachelor’s thesis was to design a cleanroom for assembly work of Hanza Toolfac Oy since the company is in the planning phase for constructing a new factory where they require a cleanroom for assembly work. Additional to the layout design of cleanroom, equipment that is required for designing a cleanroom is determined in this thesis.
The theory part of the thesis consist of general cleanliness of products, different methods to clean the products and requirement factors of cleanroom. In the beginning, the current state of Hanza Toolfac Oy was mapped by Gemba walk. Then with the requirement of Hanza Toolfac Oy’s level of cleanliness, the future state was mapped which even determined the ISO class of the cleanroom according to 14644-1.
Three different layout solutions were presented to Hanza Toolfac Oy
The theory part of the thesis consist of general cleanliness of products, different methods to clean the products and requirement factors of cleanroom. In the beginning, the current state of Hanza Toolfac Oy was mapped by Gemba walk. Then with the requirement of Hanza Toolfac Oy’s level of cleanliness, the future state was mapped which even determined the ISO class of the cleanroom according to 14644-1.
Three different layout solutions were presented to Hanza Toolfac Oy